Schoeps Switchable-pattern ST

Product Description

Schoeps MK 5 Omni/Cardioid Capsule
The MK 5 offers two selectable directional patterns, but uses only one membrane – a no-compromise approach. The fact that full response is maintained to the highest audible frequencies is unusual for a switchable-pattern microphone.

In its omnidirectional setting the MK 5 is a true pressure transducer with smooth, extended low-frequency response, low sensitivity to most wind and breath noise, handling noise or mechanical vibration, and no proximity effect.

Unlike conventional, dual-diaphragm multi-pattern microphones, its cardioid setting retains its full directionality even at very low frequencies. The benefits of this design in purity and clarity of sound are immediately audible.

The MK 5 has a slight high-frequency emphasis as compared with the corresponding single-pattern omni (MK 2) and cardioid (MK 4).

Features

• Omni and cardioid patterns, mechanically switchable
• Broad range of applications
• Preferred uses similar to those of the MK 2 or MK 2S and the MK 4:
• In the cardioid setting: for use with singing or speaking voices or most instruments, as a spot microphone, and for stereo recording with coincident, ORTF or M/S microphone arrangements
• In the omni setting: for recording instruments, singers, etc. at relatively close range

The Schoeps CMC 6 Amplifier is designed for standard 48- and 12-Volt phantom powering. Its circuitry recognizes the supply voltage and adjusts itself automatically. Its performance characteristics remain essentially the same either way; mainly, the difference is that the current drawn at 12 Volts is greater than at 48 Volts. However, the 12-Volt mode consumes less power and might be preferred for battery-powered recording.

Features

• Flat frequency response
• Extremely low noise and distortion
• Balanced, very low-impedance output
• Can be used with very long cables
• Well-protected against RFI
• For use with 12- or 48-Volt phantom powering

The microphone amplifier provides the electrostatic charge which the capsule requires in order to produce a signal. Since only a minuscule amount of current is contained in this signal, amplification of the current is required. To avoid interference to the signal on the way from the microphone to the input of the mixer or preamp, the signal is conveyed at low impedance and in balanced form. The CMC 6 amplifier offers a symmetrical, transformerless, direct-coupled Class A output stage with low impedance, low distortion, and high freedom from interference.

Please note:
The two amplifiers in a stereo pair of microphones should be of the same type. On request, Schoeps can select ”matched pairs” of capsules with equal sensitivity and frequency response for critical applications, at slight additional cost.