Furman Merit M-8S Power Conditioner

Product Description

The Merit M-8S Power Conditioner is the perfect low-cost AC power solution for any rack mount system. Install an M-8S in to the top slot of your rack, and the eight switched outlets in the rear panel will power up and protect all your equipment up to a 15-amp load.

Specifications:

Maximum AC Current Rating:

• 15 Amps, 120 VAC (Thermal breaker)
• AC Cord: 14AWGx3, 10 feet, black, fixed,
• NEMA 5-15P plug

AC Receptacles:

• Convenience Outlet (Front Panel): 1 Un-switched NEMA 15-5R
• Rear Panel Outlets:
  
  • 2 Un-switched NEMA 5-15R (1 duplex)
  • 6 Sequenced NEMA 5-15R (3 duplexes, each controlled by separate relay)

Surge Protection:

• AC Surge Protection: Merit Class (sacrificial)
• Spike Protection Mode: Line to neutral, zero ground leakage
• Max Continuous Operating Voltage: 130V RMS
• Max Clamp Voltage: 500 Volts Peak
• Peak Impulse Current: 12,000 Amps
• Energy Rating (2 X 820μS): 225 Joules

AC Filtering:

• Pi LCR Filter
• Noise Attenuation: >26dB, 100 Khz to 1 MHz

Operating Temperature Range:5C (40F) to 40C (105F) degrees

Humidity Range:<90% rH (Relative Humidity)

User Interface:

• Rocker Switch: Front panel, Sequence (ON, OFF)
  
  • Thermal Circuit Breaker: Front panel, push to reset
  • Front panel indicators Delay 1, Delay 2, Delay 3, Power, Protection OK
• Control/Status/Triggering (Rear Panel):
• Rear Panel DIP Switches: 12V Mode On/Off,
  
  • GND Mode On, Momentary/Maintained
  • Potentiometer: Rear panel, time calibration fine tune delay adjust
  • Remote Terminal: +5-30VDC In, 12VDC (12mA) Out
  • Remote Terminal: Phoenix type 4-Pin Connector with Screw terminals; +12V, STAT, REM, GND (Class 2 Wiring)

Size: 1.75” X 19.00” X 6.5” (HWD) – ANSI 1RU

Mass: 5.3 lbs

Dimensions: 8.75”D x 19”W x 1.75”H

Weight: 6.5 lbs

Power Consumption (No Load): • 5 Watts

Safety Agency: C/CSA/US